Oops! I gave y'all some wrong information. The OEM door lock module also sends a one-shot signal to the solenoids. What do y'all think about designing a new door lock module that senses current draw to test the state of the door locks? This would give me the feed-back loop that I'm looking for without adding new wires in the door. -----Original Message----- From: David Swingle <dswingle@xxxx> To: Walter <Whalt@xxxx> Date: Monday, December 11, 2000 10:37 PM Subject: Re: Door lock module >Welll - not exactly. The OEM circuit is a one-shot as well. There is no >feedback loop. >----- Original Message ----- >From: "Walter" <Whalt@xxxx> >To: <dmcnews@xxxxxxxxxxx> >Sent: Monday, December 11, 2000 8:30 PM >Subject: Door lock module (was Steering Wheel recovering) > > >> What happens with the OEM lock module is it sends current to the lock >> solenoids until they move. If they fail to move, then they burn up >trying. > >