Re: [DML] Cruise Control (Audiovox CCS100)

["content22207 <brobertson@xxxx>" <brobertson@xxxx>]

Since you suggested to list, I ask details in this forum:

I've got the same unit not yet installed. What did you use for pulse
generation? Am considering tying into Lamda sender on speedo cable. If
you did same, how many PPM's did you set it for (SW1 and SW2)?

Supplied cable on servo is way too long. Where did you install? Am
considering shortening cable to fit servo in engine compartment
(driver's pontoon).

My rheostat is DOA (not even part of modified headlight circuit) so
that's where I plan to install the dash control. Will route wires
through shaft hole, and keep the clock (it's at such a convenient
angle to view!).

Bill Robertson
#5939

>--- In dmcnews@xxxxxxxxxxxxxxx, jwit6@xxxx wrote:
> I have an AudioVox CCS 100 installed. If you don't mind parting with
the clock, the control unit fits directly into its place without
alteration. You can save the clock and keep it with the car to put
back in later if you want.JC Whitney for $89.000.
> Jim 6147
> 
> 
> "milo4845 <wayne@xxxx>" <wayne@xxxx> wrote:
> 
> >I have a 1983 5 Speed. I want to install a Cruise Control. Any 
> >suggestions? 
> >
> >
> >
<snip -- excess message footers cut>