Re: [DML] Cruise Control (Audiovox CCS100)

[id <ionicdesign@xxxx>]

the delorean doesnt have pulse generator on the spedo cable, or anywhere on the vehicle,
the lamda sensor is mechanical not electonical. you have to install magnets on one of
the drive shafts.

mark

"content22207 " wrote:

> Since you suggested to list, I ask details in this forum:
>
> I've got the same unit not yet installed. What did you use for pulse
> generation? Am considering tying into Lamda sender on speedo cable. If
> you did same, how many PPM's did you set it for (SW1 and SW2)?
>
> Supplied cable on servo is way too long. Where did you install? Am
> considering shortening cable to fit servo in engine compartment
> (driver's pontoon).
>
> My rheostat is DOA (not even part of modified headlight circuit) so
> that's where I plan to install the dash control. Will route wires
> through shaft hole, and keep the clock (it's at such a convenient
> angle to view!).
>
> Bill Robertson
> #5939
>
> >--- In dmcnews@xxxxxxxxxxxxxxx, jwit6@xxxx wrote:
> > I have an AudioVox CCS 100 installed. If you don't mind parting with
> the clock, the control unit fits directly into its place without
> alteration. You can save the clock and keep it with the car to put
> back in later if you want.JC Whitney for $89.000.
> > Jim 6147
> >
> >
> > "milo4845 <wayne@xxxx>" <wayne@xxxx> wrote:
> >
> > >I have a 1983 5 Speed. I want to install a Cruise Control. Any
> > >suggestions?
> > >
> > >
> > >
> <snip -- excess message footers cut>
>
> To address comments privately to the moderating team, please address:
> moderators@xxxx
>
> For more info on the list, tech articles, cars for sale see www.dmcnews.com
>
> To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/