Re: [DML] update on speedo noise

["K Creason" <dmc4687@xxxx>]

Hmmm... the cable from AD seems to be fused with the cup. I am trying a
punch before I break the AD by pulling the cable end out.

----- Original Message -----
From: "K Creason" <dmc4687@xxxx>
To: <dmcnews@xxxxxxxxxxxxxxx>
Sent: Sunday, October 07, 2001 4:07 PM
Subject: Re: [DML] update on speedo noise


> Another Question...
> if you turn the LF wheel by hand while it's on jacks can you normally hear
> clicks and action from inside angle drive at the start of the motion? Or
> should I be working this problem until the AD is completely silent?
>
> ----- Original Message -----
> From: "K Creason" <dmc4687@xxxx>
> To: <dmcnews@xxxxxxxxxxxxxxx>
> Sent: Sunday, October 07, 2001 1:46 PM
> Subject: Re: [DML] update on speedo noise
> > I can't remove my dustcap. It was kind of like glued around the cap, but
> > I've broken that loose but it still won't pop out. Is it suppossed to be
> > that tight?
> >
> > Also, I bought a quart of gear oil (85w/140) and a needle for my grease
> gun.
> > Which is better for the angle drive, heavy gear oil (is that heavy
> enough?)
> > or regular grease injected via needle & gun?
> >
> > ----- Original Message -----
> > From: "K Creason" <dmc4687@xxxx>
> > Sent: Saturday, October 06, 2001 8:25 AM
> > > I've been trying to narrow down the source of my speedo noise. To
recap,
> > the
> > > speedo works great, is accurate, but it there is a clicking noise, at
> > least
> > > up to 45mph. At a slight roll it's a very loud clack, but is only
every
> > few
> > > seconds. At 40mph is isn't always noticeable, and there is just a
slight
> > > shiver to needle.