RE: [DML] Galvanizing frame?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DML] Galvanizing frame?



I knew I had read about galvanizing somewhere:

Delorean World, Volume 9 number 1, 1992. "Rust Never Sleeps II" by Mike
Roberts.

In the article, Mike attempted to have a frame stripped in Methylene
Chloride, but could not find anyone with a tank large enough to hold the
entire frame. Plus, it was slow-going and required multiple treatments. He
finally found someone to just chuck it in the galvanizing tank, epoxy and
all, with the idea that it would burn off. It did, but make thick fumes and
required 4 dips in the tank. The galvanizer was not receptive to doing it
again. Mike said it was $400 but that was in 1992.

You should read the article, it's quite informative.


Gus Schlachter
Austin, TX
VIN# 4695


> -----Original Message-----
> From: njp548@xxxx [mailto:njp548@xxxx]
> Sent: Thursday, August 10, 2000 12:20 AM
> Subject: [DML] Galvanizing frame?
>
>
> hey List,
>
> I am just about ready to have my frame chemically dipped then
powdercoated,
> and I was wondering if anyone on the list had their frame galvanized
before
> they had it powdercoated? Also, about how much did it cost them to
> galvanize? Thanks in advance.
>
> Later,
> Nick
> 1852
>






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated