[DMCForum] Re: PRV Dwell Angle

["cruznmd" <racuti1@xxxxxxxxxxxx>]

The manual definitely says dwell cannot be adjusted-
I may have mis-read what value cannot be detected by an O-scope.


--- In DMCForum@xxxxxxxxxxxxxxx, Martin Gutkowski - DMUK 
<martin@xxxx> wrote:
> Been there, done it, The output is very low current but a scope 
will 
> have no problems with it - but the signal itself is very dirty.
> 
> Martin
> 
> content22207 wrote:
> 
> > If PRV "pulse coil" is anything like a standard hall effect 
sensor, I
> > see no reason why you couldn't attach an oscilloscope. Are you 
sure
> > the manual doesn't state that dwell angle can't be ADJUSTED?
> > 
> > An analog volt meter can measure voltage through the sensor even 
with
> > wave forms (yet another example of older technology triumphing 
over
> > its successor).
> > 
> > Bill Robertson
> > #5939
> >

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.