Re: [DMCForum] Re: PRV Dwell Angle

[Martin Gutkowski - DMUK <martin@xxxxxxxxxxxxxx>]

No - I was replying to the question of whether the output can be scoped 
- nothing to do with dwell angle - what is that anyway? suspect it's an 
american term

Martin

cruznmd wrote:

> The manual definitely says dwell cannot be adjusted-
> I may have mis-read what value cannot be detected by an O-scope.
> 
> 
> --- In DMCForum@xxxxxxxxxxxxxxx, Martin Gutkowski - DMUK
> <martin@xxxx> wrote:
>  > Been there, done it, The output is very low current but a scope
> will
>  > have no problems with it - but the signal itself is very dirty.
>  >
>  > Martin
>  >
>  > content22207 wrote:
>  >
>  > > If PRV "pulse coil" is anything like a standard hall effect
> sensor, I
>  > > see no reason why you couldn't attach an oscilloscope. Are you
> sure
>  > > the manual doesn't state that dwell angle can't be ADJUSTED?
>  > >
>  > > An analog volt meter can measure voltage through the sensor even
> with
>  > > wave forms (yet another example of older technology triumphing
> over
>  > > its successor).
>  > >
>  > > Bill Robertson
>  > > #5939
>  > >
> 
> 
> Yahoo! Groups Sponsor
> ADVERTISEMENT
> <http://us.ard.yahoo.com/SIG=129157p4r/M=295196.4901138.6071305.3001176/D=groups/S=1705126215:HM/EXP=1091809651/A=2128215/R=0/SIG=10se96mf6/*http://companion.yahoo.com>
> 
> 
> ------------------------------------------------------------------------
> Yahoo! Groups Links
> 
>     * To visit your group on the web, go to:
>       http://groups.yahoo.com/group/DMCForum/
>        
>     * To unsubscribe from this group, send an email to:
>       DMCForum-unsubscribe@xxxxxxxxxxxxxxx
>       <mailto:DMCForum-unsubscribe@xxxxxxxxxxxxxxx?subject=Unsubscribe>
>        
>     * Your use of Yahoo! Groups is subject to the Yahoo! Terms of
>       Service <http://docs.yahoo.com/info/terms/>. 
> 
> 
> .

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.