RE: [DMCForum] vacuum for making D parts

["timnagin" <timnagin@xxxxxxxxxxxxxx>]

Andrei,

I am not real familiar with the different types of plastics used in
vacu-forming but the one I have seen didn't seem strong enough to provide
any real support.  I know the carbon fiber mat is a lot more expensive
than
the fiberglass, but I would think either one would be strong enough where
the plastic would be of little to no benefit, true?

The vacu-formed piece could also be used as the master to make other molds
which would save a lot of time and the end product  a better and
consistent
fit as well should other pieces be created.

Greg



-----Original Message-----
From: Andrei Cular [mailto:acular@xxxxxxxxxxxxxxx]
Sent: Sunday, August 04, 2002 4:17 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: Re: [DMCForum] vacuum for making D parts


Greg

I think what Walt wants to do is use the vac part for the structure so you
only have to use a single layer of the expensive carbon cloth.



Andrei



To unsubscribe from this group, send an email to:
DMCForum-unsubscribe@xxxxxxxxxxxxxxx

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

<<attachment: winmail.dat>>