RE: [DML] Cruise Control (Audiovox CCS100)

["Scott Mueller" <scott.a.mueller@xxxx>]

How did you connect the servo to the throttle cable. How did you deal with
the throttle cable slack when the cruise control was active.

Scott Mueller
002981
RNDOLA


-----Original Message-----
From: jwit6@xxxx [mailto:jwit6@xxxx] 
Sent: Saturday, February 08, 2003 3:10 PM
To: dmcnews@xxxxxxxxxxxxxxx
Subject: Re: [DML] Cruise Control (Audiovox CCS100)


Pulse generation comes from the included CCS-203 magnet kit mounted on the
left inboard cv joint housing.

I have PPM set to 2,000 (sw1 off, sw2 off )

Speed Signal with the magnet kit is VSS&Tach (sw3 on)

Servo is mounted on the left side engine compartmnet using one of the
existing 6mm studs you'll find there.

Sensitivity is set to low (sw4 on, sw5 off), but I have EFI and custom
intake. You'll know if you have to change it.

Control switch is norm open (sw6 off )
Tach select is "coil" (sw7 on)

Jim 6147


"content22207 <brobertson@xxxx>" <brobertson@xxxx> wrote:

>Since you suggested to list, I ask details in this forum:
>
>I've got the same unit not yet installed. What did you use for pulse 
>generation? Am considering tying into Lamda sender on speedo cable. If 
>you did same, how many PPM's did you set it for (SW1 and SW2)?
>
>Supplied cable on servo is way too long. Where did you install? Am 
>considering shortening cable to fit servo in engine compartment 
>(driver's pontoon).
>
>My rheostat is DOA (not even part of modified headlight circuit) so 
>that's where I plan to install the dash control. Will route wires 
>through shaft hole, and keep the clock (it's at such a convenient angle 
>to view!).
>
>Bill Robertson
>#5939
>
>>--- In dmcnews@xxxxxxxxxxxxxxx, jwit6@xxxx wrote:
>> I have an AudioVox CCS 100 installed. If you don't mind parting with
>the clock, the control unit fits directly into its place without 
>alteration. You can save the clock and keep it with the car to put back 
>in later if you want.JC Whitney for $89.000.
>> Jim 6147
>> 
>> 
>> "milo4845 <wayne@xxxx>" <wayne@xxxx> wrote:
>> 
>> >I have a 1983 5 Speed. I want to install a Cruise Control. Any
>> >suggestions? 
>> >
>> >
>> >
><snip -- excess message footers cut>
>
>
>
>To address comments privately to the moderating team, please address: 
>moderators@xxxx
>
>For more info on the list, tech articles, cars for sale see 
>www.dmcnews.com
>
>To search the archives or view files, log in at 
>http://groups.yahoo.com/group/dmcnews
>
>Your use of Yahoo! Groups is subject to 
>http://docs.yahoo.com/info/terms/
>
>
>


To address comments privately to the moderating team, please address:
moderators@xxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at
http://groups.yahoo.com/group/dmcnews 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/