Re: Installing ignition dist
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Installing ignition dist



--- In dmcnews@xxxxxxxxxxx, "DMC Joe" <dmcjoe@xxxx> wrote:
> To position the #1 cylinder at TDC, with the aid of an assistant, 
bump the
> starter via the ignition switch or put the car in gear and push the 
car
> until the crankshaft pulley #1 cylinder notch is lined up with the 
#1
> cylinder plate notch. Reinstall the distributor by positioning the 
rotor
> approximately 30 degrees clockwise of the #1 reference notch in the 
rim of
> the distributor. 

---- there's one more detail. You have to make sure that you are on 
the compression stroke (both valves closed) - it's a 4-cycle engine. 

Dave






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated