Re: [DML] Re: Installing ignition dist
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Re: Installing ignition dist



To position the #1 cylinder at TDC, with the aid of an assistant, bump the
starter via the ignition switch or put the car in gear and push the car
until the crankshaft pulley #1 cylinder notch is lined up with the #1
cylinder plate notch. Reinstall the distributor by positioning the rotor
approximately 30 degrees clockwise of the #1 reference notch in the rim of
the distributor. (This is a somewhat complex procedure that should be
performed by individuals with some experience with automobile ignition
systems.)

Caution: VOLTAGES PRODUCED BY THE IGNITION SYSTEM CAN CAUSE A SEVERE
ELECTRICAL SHOCK, WHICH UNDER CERTAIN CONDITIONS CAN BE LETHAL.

"We're here to help you"

DMC Help / De Lorean Services / <dmchelp@xxxx>
Web Site: <www.deloreanservices.com>

----- Original Message -----
From: <deloreanernst@xxxx>
To: <dmcnews@xxxxxxxxxxx>
Sent: Wednesday, October 04, 2000 9:25 AM
Subject: [DML] Re: Installing ignition dist


> In a message dated 10/3/00 11:55:22 PM Eastern Daylight Time,
> Delorean17@xxxx writes:
>
> << Do I get the # 1 firing cylinder in the firing position and have the
> distributor rotor pointed at the small mark on the inside of the
distributor
> housing? and then put the cap on it? question, How do I get the #1
cylinder
> in the correct firing position? what number should the mark on the
pulley
> line up with? ...email me privately. >>
> (quote snipped)
> David,
> those are very good questions- I'd like to know the answer too. Please
post
> the responses to the DML.
>
> -Wayne
> 11174







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated