In a message dated 10/3/00 11:55:22 PM Eastern Daylight Time, Delorean17@xxxx writes: << Do I get the # 1 firing cylinder in the firing position and have the distributor rotor pointed at the small mark on the inside of the distributor housing? and then put the cap on it? question, How do I get the #1 cylinder in the correct firing position? what number should the mark on the pulley line up with? ...email me privately. >> (quote snipped) David, those are very good questions- I'd like to know the answer too. Please post the responses to the DML. -Wayne 11174