Re: [doc] finally driven her!!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [doc] finally driven her!!
- From: "blackaddertoo" <blackaddertoo@xxxxxxxxxxx>
- Date: Mon, 01 Aug 2005 00:18:16 -0000
Hi thanks for the advice
i'll start perhaps with the 02 sensor as its an easy one to do.
i'm not looking forward to the plugs etc, looks a long job! and
expensive as while you are there you might as well replace leads,
cap, rotor, water pump pipes etc.
by the way i have a small leak coming from behind the water pump, i
assume its the weak hose to the pump needs sorting, i understand a
common problem.
the T panel just won't budge, seems the the foam under is sticking
to the panel, may try a hairdryer to heat the panel carefully.
regards
Steve
--- In doc-uk@xxxxxxxxxxxxxxx, tny1964@xxxx wrote:
> mine was the same, after i replaced the injectors! a new set i got
with my
> car. turns out the previous owner had sodded about with the
adjusting screws on
> the throttle assy,and the throttle wasn't shutting properly
after i
> sorted that it seems ok. but that was after replacing the cpr. you
just have to
> check for air leaks just try to eliminate everything cheers tony
>
>
> [Non-text portions of this message have been removed]
DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **
SPONSORED LINKS
YAHOO! GROUPS LINKS
Back to the Home of PROJECT VIXEN