Re: [doc] Interior lights no-op, SORTED
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [doc] Interior lights no-op, SORTED
- From: "Phill Wright" <psw@xxxxxxxx>
- Date: Wed, 25 May 2005 11:48:36 -0000
Thanks Richard!!!
Yep, that was exactly it, all working hunky dory with a 15 sec delay.
Headliners have been replaced. The rear light was also wired up wrong
and that doesn't come out to change the headliners, so why that was
wrong as well is a mystery. Anyway, as usual, the best place to check
first is the forum!
Thanks for the help all!
Phill W
DOC 233
VIN 6772 (sorbet)
Avantime (M4TRA)
--- In doc-uk@xxxxxxxxxxxxxxx, "Richard Hanlon" <rahanlon@xxxx> wrote:
> On mine, I had the same - I eventually traced the fault to the
lights
> themselves being wired up incorrectly (probably after the head-
lining was
> replaced back in the USA). It now works as intended with the
purple at the
> end where there's only one contact, and the black and the (purple
and white)
> at the other. Swapping the black and (purple and white) with each
other
> controls whether the 'courtesy' function operates when the lens
points
> forwards or backwards, with the 'fully on' being the other position.
>
> And, you might find the time delay circuit can be a bit sporadic -
you don't
> always seem to get the 'fade' function, depending on how long the
door's
> been open.
>
> My diodes turned out to be Ok in the end, but this is no guarantee
that
> yours are, of course!
>
> Good luck,
>
> Rich Hanlon
> (393/06126)
>
>
>
> >From: Martin Gutkowski <martin@xxxx>
> >Reply-To: doc-uk@xxxxxxxxxxxxxxx
> >To: doc-uk@xxxxxxxxxxxxxxx
> >Subject: Re: [doc] Interior lights no-op, anyone had this
> >Date: Wed, 25 May 2005 00:47:17 +0100
> >
> >It'll be one of the diodes. I have a couple of original spres if
you
> >need any
> >
> >Martin
> >
> >Phill Wright wrote:
> >
> > > Hi - 'Door Ajar' - its that that doesn't work, the door markers
are
> > > fine - the same switch does the interior lights so the switch
is ok,
> > > and the interior lights work when set to 'on' on the actual
> > > illuminated switch, so thats ok - has to be a wiring issue -
I'll
> > > untape the bunch of diodes and have a look see if it a bad
contact
> > > there issue... Ta
> > >
> > > Phill W
> > > DOC 233
> > > VIN 6772(sorbet)
> > > Avantime(M4TRA)
> >
> >
DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **
Yahoo! Groups Links
Back to the Home of PROJECT VIXEN