RE: [doc] Wiring Harness

["Kevin Milliken" <kevin.milliken@xxxx>]

HI John

What you are proposing is a a bit extreme!

My suggestion before going down this road is to disconnect the front harness
from all connections, then to do continuity checks before taking it all out.

>From experience it is most unlikely that you will find a broken cable more
likely a bad connection. You could spend a fortune chasing shadows
otherwise. Nick is pretty nifty on the electrical he may post an opinion if
he reads this.


Regards


Kevin #5959
-----Original Message-----
From: jchapelhow [mailto:chapelhow@xxxx]
Sent: 15 September 2003 19:59
To: doc-uk@xxxxxxxxxxxxxxx
Subject: [doc] Wiring Harness


All.

Let us suppose that I had decided to cut my losses and cure my
electrical problems by replacing the entire front electrical harness,
aside from the cost of the item from DMCH (or other chosen supplier)
there does not seem to be any info in the manual for how this is
achieved. Specifically I would like to rule out the connection point
as the cause of my headaches but it is not obvious where the
front/main harness join. If I look at the DMCH parts exploded diagram
it looks like there should be an obvious connector block, does anyone
have any ideas where?

As a further aid to diagnostics is there a easily accessible ground
point anywhere under the dash to avoid the cabling to the connecions
by the front wheel. This would help me rule out these connectors.

John Chpaelhow
DOC 19 : Boeing (My a 1:1 DeLorean model!) 0737


Yahoo! Groups Sponsor
ADVERTISEMENT




DOC UK Website: www.delorean.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed
public and may be printed in the club magazine **

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.


[Non-text portions of this message have been removed]