 
Re: [doc] couple of tech  questions
    
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [doc] couple of tech  questions
- From: "blackaddertoo" <blackaddertoo@xxxxxxxxxxx>
- Date: Thu, 02 Feb 2006 01:17:04 -0000
hi Nick
yeh thanx, i also have some 'liquid tape' from frost which is pretty 
good and i used this to repair the wires behind the front grill 
which Mr mouse had chewed. (no damage to core though) and they all 
still worked ok.
he's also nibbled the rear of the indicator units.
luckily the interior was not to his taste! so interior is good but 
needs a very good clean and new leathers on the seats.
Door seals are also shot.
i'll hopefully do a bit more Saturday morning (misses willing!), and 
i've ordered new rpm relay, as its a bit worrying if the fuel pump 
runs when the engine has stalled. will test the coil, and clean the 
contacts and unplug the lambda system to see if it has any effect
-should run rich, i can then test the lambda leads. Definately 
powers up as the frequency valve buzzes.
Regards
Steve
--- In doc-uk@xxxxxxxxxxxxxxx, Nick Tomlinson 
<nickandkathryntomlinson@...> wrote:
>
> If the blue shielded cable just has the plastic chewed so just 
exposing the outer shield then all I would do is put some heat 
shrink tube over it and heat it till it shrinks.
>   If you can see the inner core then you would ideally need to 
remake the cable with new shielded wire in the ecu. The shieling 
ends at the bulkhead anyway.
>    
>   Richard Hutchinson shoud be able to do that in a jiffy if you 
cross his palm with silver :)
>    
>   NickT.
> 
> blackaddertoo <blackaddertoo@...> wrote:
>   so far i found one mouse nest behind the front grill and one in 
the 
> cubby box behind driver, and some rubbish round the idle ecu.
> the wire from the lambda sensor has some chew marks and has 
exposed 
> the shield part of the cable.
> maybe i should pull out the lambda ecu to see if the mouse had 
chips 
> for dinner!!!!.
> not sure yet how i can replace the shielded wire as its built into 
> the connector i think.
> 
> Regards
> 
> Steve
> 
> 
> 
> 
> --- In doc-uk@xxxxxxxxxxxxxxx, Nick Tomlinson 
> wrote:
> >
> > Have you tried disconnecting the rat from the wiring :)
> > 
> > NickT.
> > 
>             
> ---------------------------------
> Yahoo! Photos ? NEW, now offering a quality print service from 
just 8p a photo.
> 
> [Non-text portions of this message have been removed]
>
DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **
  
  
  
  YAHOO! GROUPS LINKS
  
 Back to the Home of PROJECT VIXEN
 Back to the Home of PROJECT VIXEN