[doc] Info for Rich H

["nick12dmc" <Tammyfew@xxxxxxx>]

Hi Rich,
        Nice to see you at the NEC. Here is the info. on the Flywheel
holding tool. Check out www.Lasertools.co.uk. Part No.3203.
Put a bolt through the slot into the lower mounting hole for
the starter motor and put a nut on the other side, adjust the teeth
so they mesh with the flywheel. The engine is then locked. and the
pulley nut should be a lot easier to get off.
Cost about £7. Propane torch I used burns MAPP gas. This burns 
extra hot and was better than my little propane blowlamp.
All the best
Nick H





DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/doc-uk/
   
• To unsubscribe from this group, send an email to:
  doc-uk-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.