Re: [doc] Pulley Nut Help

[Martin Gutkowski <martin@xxxxxxxxxxxxxx>]

The problem with using a big bar is that you will bust your right-hand 
engine mount getting it off. And you won't be able to apply enough 
torque if just using the 5-th-gear-stand-on-brakes method. You'll need 
the flywheel locking tool

Martin

nick12dmc wrote:

> This sounds a bit extream Rich! mind you in my frame of mind last
> night C4 plastic explosive was looking like a good idea.
> A friend of mind who is a mechanic poped round today.
> The nut even resisted him. I am going round to his workshop tommorow
> to pick up a large 3/4 drive Mega rachet which is about 1 meter long.
> This coupled with a massive pair of stilson's on the pulley and
> heating the nut up with a top of the line propane mix torch.
> The pulley is probably going to get trashed although we will wrap
> rag round it.
> This should get it off.
> The main problem is the nut has Loctight 601 which my mechanic
> friend says is the main problem. We have to get it hot to burn this
> out.
>
> Regards
> Nick H
>




DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/doc-uk/
   
• To unsubscribe from this group, send an email to:
  doc-uk-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.