Re: [DML] brake paint

["A.H. MacIntosh & Co." <dmc12@xxxx>]

The POR should be topcoated with hardnose for added resistance... but I have
yet to see ANY coating that was "brake fluid proof". POR is quite resistant
to brake fluid. Even Eastwood's brake parts coating is only marketed as
being "resistant" to fluid. The biggest advantage POR has, is that it
applies well over a rusted surface, and stays on.

Best solution, don't take a bath in brake fluid, when bleeding the system...
it shouldn't be spilling everywhere anyway!
or if you must make a mess, at least rinse it off in reasonable time.

----- Original Message -----
From: <jwit6@xxxx>
Subject: Re: [DML] brake paint

> POR-15 will not stand up to dot 3 or 4 brake fluid. So be neat when
bleeding the brakes up.
> Jim