CV joint disassembly

[Noah <sitz@xxxx>]

I am in the midst of replacing one of my CV boots. I'll most likely wid up
replacing the lot, and repacking my CV joints at the same time (I was
going to do it in stages, but these things just seem to cascade, don't
they?)

IN any event, I've got the axle pulled, and it is currently sitting on a
nice clean-but-not-for-much-longer surface. I've looked at the link of
dmcnews.com, and it looks like it's going to be a great help. Right after
I figure out how to pop off that end cap. Does it just pry off, or is
there Super Seekrit Voodoo(tm) involved? Tips/tricks/explanations welcome.
:)

As an aside, the copper cap on the tranny side looks as though something
got angry at it at some point in its past; it's quite dented. Is this
mechanically dangerous, or just aesthetically displeasing? Thanks much,
alll.

Noah
#2867, currently in a few pieces

Sticks! Sharp, pointy sticks! Why can I never find any!!