In a message dated 6/27/01 1:01:11 AM Eastern Daylight Time, wiltzius@xxxx writes: > Is there truth to this rumor or is it possible to just > swap out the plastic line for the steel one? Any insights/experiences > welcome! > > I did my master cylinder and slave at the same time, but that was by choice. (Those two you SHOULD replace together. Mine were pretty nasty looking.) The workshop manual says you have to lift the body slightly off the frame to replace the clutch line, (!) but that isn't necessary. Just leave the old one, and run the new S.S. one in place of it. -Wayne A. Ernst DMCTech Group [Non-text portions of this message have been removed]