Re: [DML] muffler heat shield

["Sean Howley" <tsuyoi@xxxx>]

About a year and a half ago, I made a two layered heat shield to replace the
torn-up asbestos one. I included a "lip" on the bottom to aid in pulling
air in-between the stainless sheets for reducing the heat transfer between
the sheets. I have not had any problems, however, I do need to add a spacer
in one location as the stainless sheets tend to contact each other due to
lack of support in that area (center/top area of the shield). It also looks
pretty good.

Sean Howley
VIN#2345

> Haven't seen it, but they say they're coming out with a new two layer one
> that's even better. I grilled him about via e-mail.
> PJ Grady has one that isn't stainless, but is more durable than the
original.
> Haven't seen that either, but I like everything I've seen from Grady!