[DMCForum] Re: Jacking points?

["thebrave65" <johnnysher1@xxxxxxx>]

Nope.  That's exactly what happens on those spots.  And yes, the 
little metal plates are the jacking points.

If you don't want to use them, put your jack stands on the frame 
behind the crumple tubes and in front of the fuel plate.

I'm about halfway finished with my brakes.  Messy job.

Johnny
5518


> Where is the best place to jack the car up, and place the jack 
stands?
> I want to get the car completely off the ground, sitting on four 
jack
> stands so I can replace all four brakes at once. The back is easy (I
> use the rear frame, but see below for more info on this), but I have
> no idea where to place the jack or stands for the front.
> 
> More details:
> 
> I read that one should use the jack points behind the front wheels 
and
> in front of the rears. I found little round metal looking "plates" 
in
> these locations and assumed these were the jack points. So I jacked
> the back of the car up from the center of the rear frame like I 
always
> do, using a length of 2x4 to distribute the pressure more evenly, 
then
> put my jack stands at these points in front of the rear tires. When
> setting it down, however, the entire car flexed - A LOT. The front
> began to lift up, and I heard creaking and all sorts of scary 
noises,
> so I stopped letting the car down. I jacked it back up and put the
> stands in the back on the frame, which works fine.
> 
> Was I doing something wrong?
> 
> -Ryan

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.