It's been a while since I last posted a question, so here we go. Once again I find myself trying to get my central locking working. I have had my lock module upgraded and I know it works fine.. also put new solenoids in.. But still all I could do is lock both doors from the drivers side, and unlock neither from either side. The last place I hade to check was the connections under the T-panel which I have done today, there was a little corrosion on the spade terminals but nothing much, so that is now all cleaned up. Where did that get me ? Well the same position as above, however if both the doors are open and you move the lock rocker in either door the opposite one try's to move in both lock and unlock mode. once you close the doors back to square one. Is there something I need to adjust, or am I just going to have to live with it? Cheers Paul #6463 http://www.paul.salsbury.btinternet.co.uk Yahoo! Groups Sponsor <http://rd.yahoo.com/M=247865.3003379.4507215.1261774/D=egroupweb/S=170512 6215:HM/A=1482387/R=0/*http://ads.x10.com/?bHlhaG9vaG0xLmRhd=1051796897%3e M=247865.3003379.4507215.1261774/D=egroupweb/S=1705126215:HM/A=1482387/R=1 =1051796897%3eM=247865.3003379.4507215.1261774/D=egroupweb/S=1705126215:HM /A=1482387/R=2> <http://us.adserver.yahoo.com/l?M=247865.3003379.4507215.1261774/D=egroupm ail/S=:HM/A=1482387/rand=125271320> To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service <http://docs.yahoo.com/info/terms/> .
<<attachment: winmail.dat>>
Back to the Home of PROJECT VIXEN