Counter clockwise to remove, just like everything else. I had to use an acetleyne torch to get mine loose. I swear the factory used a whole tube of red loctite on it. I used an impact and a breaker bar before I used heat, heat is the only thing that worked. Be patient. Mark V On May 25, 2008, at 8:27 PM, Paul Gress wrote: > Thanks, > > 35 mm is 1.378, or just .003 larger than 1 3/8", which is what I used. > I found a nice 6 point socket at McMaster Carr, the socket I was using > was 12 point. Still don't know if when I'm loosening the Nut if I'm > really tightening it (is it left hand or right hand thread). > Frustrating when you have a 1 3/8" socket on a 3/4" drive and a > breaker > bar, and still can't get if loosened. > > Paul > > > > delorean wrote: >> 35 MM if I remember correctly. Some say it is a 36 mm but a 36 is >> loose, 35 mm is snug. Apply lots of heat to get the bolt off. >> >> Mark V >> >> > > > ------------------------------------ > > Yahoo! Groups Links > > > ------------------------------------ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/DMCForum/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/DMCForum/join (Yahoo! ID required) <*> To change settings via email: mailto:DMCForum-digest@xxxxxxxxxxxxxxx mailto:DMCForum-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/