[DMCForum] Re: Torsion bar adjustment

["Joe OBrien" <joeyoseppijoe@xxxxxxxxx>]

Yeah for launchers you might want more spring, but with new struts, 
you remember how fast your doors shoot up, once they get going. Those 
struts should work ok in January then. :-)

I recall us playing around with the hang test, but not using it as a 
guide for proper door launching. We just adjusted it till it worked 
properly with your strikers and your struts at the time.

Least that is how my foggy memory remembers it.

But, your one of the few that has launchers around here, till I get 
mine. :-)



-Joe








--- In DMCForum@xxxxxxxxxxxxxxx, Shannon Yocom <ssdelorean@xxxx> 
wrote:
>
> Not so if you have door launchers. The doors need to clear the 
striker pins by
> themselves for the launchers to work properly. Too bad we found 
this out after
> un-torque'n my doors. Remember... it was quite helpful when we did 
my doors the
> 2nd time. I just had to re-install my weaker pistons so the doors 
won't bounce at
> the top.
> 
> Grady recommends some where from 3 to 6 inches.
> 
> Shannon Y
> 16506
> 
> ---------------------
> Date: Thu, 13 Oct 2005 03:45:50 -0000
>    From: "Joe OBrien" <joeyoseppijoe@xxxx>
> Subject: Re: Torsion bar adjustment
> 
> >>snip<<
> 
> You only need to remove the strut if you want to do the dumb 2-3 
inch 
> hang test. (useles)You just adjust the doors till they are how you 
> like them.
> 
> That way you can make adjustments, and then see the results 
quickly, 
> then decide if you want to go another spline, or back off one.
> 
> Speaking from 36 doors me & Shannon have adjusted.
> 
> 
> -Joe
> 
> 
>             
> __________________________________ 
> Yahoo! Music Unlimited 
> Access over 1 million songs. Try it free.
> http://music.yahoo.com/unlimited/
>

SPONSORED LINKS

Dmc	Dml	Dmc fz10
Dmc fz1s	Delorean part	Dml forte

---

YAHOO! GROUPS LINKS

•  Visit your group "DMCForum" on the web.
   
•  To unsubscribe from this group, send an email to:
   DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---