[DMCForum] Re: Re: Torsion bar adjustment

[Shannon Yocom <ssdelorean@xxxxxxxxx>]

Not so if you have door launchers. The doors need to clear the striker pins by
themselves for the launchers to work properly. Too bad we found this out after
un-torque'n my doors. Remember... it was quite helpful when we did my doors the
2nd time. I just had to re-install my weaker pistons so the doors won't bounce at
the top.

Grady recommends some where from 3 to 6 inches.

Shannon Y
16506

---------------------
Date: Thu, 13 Oct 2005 03:45:50 -0000
   From: "Joe OBrien" <joeyoseppijoe@xxxxxxxxx>
Subject: Re: Torsion bar adjustment

>>snip<<

You only need to remove the strut if you want to do the dumb 2-3 inch 
hang test. (useles)You just adjust the doors till they are how you 
like them.

That way you can make adjustments, and then see the results quickly, 
then decide if you want to go another spline, or back off one.

Speaking from 36 doors me & Shannon have adjusted.


-Joe


            
__________________________________ 
Yahoo! Music Unlimited 
Access over 1 million songs. Try it free.
http://music.yahoo.com/unlimited/

SPONSORED LINKS

Dmc	Dml	Dmc fz10
Dmc fz1s	Delorean part	Dml forte

---

YAHOO! GROUPS LINKS

•  Visit your group "DMCForum" on the web.
   
•  To unsubscribe from this group, send an email to:
   DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---