RE: [DMCForum] Re: Spring question
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [DMCForum] Re: Spring question
- From: "timnagin" <timnagin@xxxxxxxxxxxxxx>
- Date: Mon, 22 Nov 2004 00:19:23 -0500
There are a lot of things that could effect this really. How long has the
car had the new front springs?
Greg
-----Original Message-----
From: lakelanier20 [mailto:derek4567@xxxxxxxxxxx]
Sent: Monday, November 22, 2004 12:09 AM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: [DMCForum] Re: Spring question
I took the measurements in my garage. It's probably the most level
surface I'll find around. I measured from the floor to the edge of
the wheel well of the fender (top middle-point of the circle, at the
edge of the stainless). The wheel gap above the tire is bigger on
the driver's side than on the passenger's, and when you stand in
front of the car and look at it, the driver's front corner sits a bit
higher. I mean, it's not like "Holy crap!!! What's wrong with your
car?!?!" It's really not that bad, but as the owner, it's noticeable
to me and kinda bugs me. I'm sure you all understand. :)
-Derek
--- In DMCForum@xxxxxxxxxxxxxxx, "timnagin" <timnagin@xxxx> wrote:
> In addition, if you lift up or press down on either side and it
doesn't
> rebound then you can probably bet your problem is the shock or
bushings.
>
> Where was the car when you measured this and from where did you
take the
> measurements?
>
> Greg
Yahoo! Groups Sponsor |
ADVERTISEMENT
| |
|
Yahoo! Groups Links
Back to the Home of PROJECT VIXEN