 
[DMCForum] Re: Driver's door alignment?
    
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DMCForum] Re: Driver's door alignment?
- From: "mw98gt" <mw98gt@xxxxxxxxxxx>
- Date: Fri, 20 Aug 2004 15:01:19 -0000
How are these pins moved?  It is off probably by like 1/8th of an 
inch.  Dont worry about the water, I am just grateful you had a 
latch.  I will try to get one soon.  I stopped at a gas station on 
my way out.  I bought a 32oz water bottle and drank it all before i 
reached 275, it was sooo hot and I was sooo thirsty.
Misha
--- In DMCForum@xxxxxxxxxxxxxxx, "Walter Coe" <Whalt@xxxx> wrote:
> On most doors that I have adjusted, I find that the front of
> the door dips down lower and needs to be adjusted higher.
> I'm not sure if it can be corrected with a hinge adjustment.
> It seems that the doors are twisted -- like they all were
> made wrong.  Even doors that close like new refrigerators
> still remain too low on the front.  Or is the fender & hood
> too high?  One day I'm going to remove the glass and twist
> the damn door into the shape that I think it needs to be.
> The painted passenger door that came from Samuel's car can't
> be made any worse. ;-)
> 
> Anyway, what I find that works for adjusting these doors is
> to put a piece of tape over the latch pin and then close the
> door gently over it.  If one side marks harder than the
> other side then the pin needs to be moved.  The other trick
> when moving these pins is to recognize the two main vectors
> and not accidentally change one while adjusting the other.
> Sometimes it helps to completely remove the front or rear
> pin so that misplacement of it won't interfere with
> adjusting the remaining pin.  It helps to figure out what is
> going wrong when things are bent up from an accident.
> 
> I think that the only way to keep these pins from relocating
> on their own is to cut away the plastic trim under it so
> that the pin and the spacers behind hit rest on metal and
> not plastic.  Later VINs were done this way.  Earlier VINs
> like my 03633 are not.
> 
> Hope this helps, Misha,
> Oh and sorry about not having any water here.  The tap water
> tastes bad.  I was out of bottled water.  And since my Mom
> lives a few blocks away, I usually run there for basic
> necessities.
> 
> Walt
| Yahoo! Groups Sponsor | 
|   | ADVERTISEMENT 
 ![click here]() |  | 
| ![]() | 
Yahoo! Groups Links
 Back to the Home of PROJECT VIXEN
 Back to the Home of PROJECT VIXEN