[DMCForum] Tail-light circuit boards - soldering ok?

["lakelanier20" <derek4567@xxxxxxxxxxx>]

Hi everyone, 
   I guess most people know about the "tempermental connectivity" fix 
of installing the Radio Shack machine screws and nuts through the 
rivets and tightening them down.  But I was wondering, is it ok to 
just put a drop of solder next to each of the rivets?  (so that half 
the drop touches the base of the socket, and the other half touches 
the metal surface of the circuit board).  Has anyone done this?  I 
would like to solder rather than put in the screws and nuts, but 
thought I'd ask all the experienced folk first if there are any 
problems with doing so.

Thanks,
-Derek L.
VIN 5302

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.