[DMCForum] Re: Spare no expense- Flux Capacitor (Are you listening Travis?)

[tmpintnl@xxxxxxxxx]

Rich - The male pins in the DeLorean connectors are about .125" in 
diameter, and the only female bullet connectors available are .157".  
The best way that I found to make a snug fit of the supplied female 
terminals to the DeLorean male pins is to put a slight crimp on the 
female terminal, so that it just takes the pin.  The length issue is 
resolved with a little tape or shrink tubing.  I will adjust the 
instructions to mention this issue.  I didn't want to force anybody 
to cut ends off of the DeLorean wires, and the smaller diameter 
connectors aren't to be found anywhere that I could think to look.  
Thanks.  Please let me know if there are any other issues that come 
up, or any feedback that you might have.

Toby Peterson
DeLorean Parts Northwest, LLC
www.delorean-parts.com

--- In DMCForum@xxxxxxxxxxxxxxx, "cruznmd" <racuti1@xxxx> wrote:
> The instructions have you pull both sets of red/pink and red/slate 
> male pins from the harness. Toby's females on his relay setup 
aren't deep enough to take them. I would re-terminate his vs. cutting 
up the original harness.
> 
> Rich
> 
> > 
> > --- In DMCForum@xxxxxxxxxxxxxxx, "cruznmd" <racuti1@xxxx> wrote:
> >  I installed the DPNW lock actuators today. A superior product, 
easy install. Just one question: Why did Toby put terminals on the 
black wires that mate with the existing harness, but not on the 
red/pink & red/slate wires? I gotta run to Radio Shack.

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.