[DMCForum] Re: Spare no expense- Flux Capacitor (Are you listening Travis?)

["ryanpwright" <yahoo1@xxxxxxxxxxxxxx>]

Hmmm. I just stuck mine in and wrapped it with a bit of electrical
tape. It's a tight connection, just leaves a tiny bit of the original
harness' contact sticking out. I saw no need to reterminate the wires.

-Ryan

--- In DMCForum@xxxxxxxxxxxxxxx, "cruznmd" <racuti1@xxxx> wrote:
> The instructions have you pull both sets of red/pink and red/slate 
> male pins from the harness. Toby's females on his relay setup aren't 
> deep enough to take them. I would re-terminate his vs. cutting up the 
> original harness.
> 
> Rich
> 
> --- In DMCForum@xxxxxxxxxxxxxxx, "Joe OBrien" <joeyoseppijoe@xxxx> 
> wrote:
> > I'm about to get a set of the DPNW actuators, so exactly what part 
> > was missing that you had to scrounge parts for at Radio Shack? I 
> > thought it was a straightforward installation with the needed parts 
> > supplied. Just curious if you could let me know of any "special" 
> > procedured needed to install them.
> > 
> > Thanks,
> > 
> > Joe O'Brien
> > 
> > 2524 & 16634
> > 
> > 
> > 
> > 
> > --- In DMCForum@xxxxxxxxxxxxxxx, "cruznmd" <racuti1@xxxx> wrote:
> >  I installed the DPNW
> > > lock actuators today. A superior product, easy install. Just one
> > > question: Why did Toby put terminals on the black wires that mate 
> > with
> > > the existing harness, but not on the red/pink & red/slate wires? I
> > > gotta run to Radio Shack.

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.