[DMCForum] slave cylinder

["cruznmd" <racuti1@xxxxxxxxxxxx>]

For the love of Christ!

This is a horrible job. I've removed the fuel system for better 
access. The heater system hoses are in the way and I'm not taking 
them apart.

The line fitting has rusted to the line. I found out today, that the 
stainless braided line doesn't replace the entire line. It goes from 
the hard line at the cylinder to the hard line at the clutch. It 
doesn't replace the whole thing so it's not going to do me any good 
(beyond replacing the icky plastic). I'm going to have to cut the 
hard line, flare it and re-fit it.

On top of that, I was flipping a fuel line out of my face, and I lost 
my balance and yanked it right off of the banjo fitting!

Once this crap is done, I hope nothing else goes wrong before the 
Spring Social.

Is anyone here going to that by-the-way?

Rich A.
#5335

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.