My R30 has same. FYI: was colossal pain to attach hose after upper air assembly in place, and very difficult to maneuver hose over distributor if attached first. Now of course just holds a 3/4" vaccum cap. At least doesn't leak air like O ring. On Louie G's #10115 (God rest its stainless steel soul) we wrapped a little electrical tape around longer DMC tube to get vacuum tight seal where it meets O ring. Worked excellent for 12 hours. Bill Robertson #5939 >--- In DMCForum@xxxxxxxxxxxxxxx, Martin Gutkowski <webmaster@xxxx> wrote: > That's how Volvo did it in the 760 over here (B28E). We have a DeLorean > in at the moment with the same setup - it has lots of Volvo bits because > it had an engine fire and the owner reconstructed the top end of the > engine with bits from a scrap Volvo engine. Perhaps the Volvos over your > side with the same engine also had it. > > Martin > > Walter Coe wrote: > > >I worked on another DeLorean recently that had this tube modified. I think > >it was done by PJ Grady. The brass tube was cut so that only a short nipple > >is used. It looked like it was epoxied into the mixture unit. The other > >end had a longer rubber hose with an elbow at the end. I like this so much > >that I'm going to ask Rob if he knows about this. > > > > Yahoo! Groups Sponsor ADVERTISEMENT <http://rd.yahoo.com/M=194081.3897168.5135684.1261774/D=egroupweb/S=170512 6215:HM/A=1732163/R=0/SIG=11n0nglqg/*http://www.ediets.com/start.cfm?code= 30510&media=zone> click here <http://us.adserver.yahoo.com/l?M=194081.3897168.5135684.1261774/D=egroupm ail/S=:HM/A=1732163/rand=348328680> To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service <http://docs.yahoo.com/info/terms/> .
<<attachment: winmail.dat>>
Back to the Home of PROJECT VIXEN