Re: [doc] re rear hub removal...help!!!

["blackaddertoo" <blackaddertoo@xxxxxxxxxxx>]

--- In doc-uk@xxxxxxxxxxxxxxx, Martin Gutkowski <martin@xxxx> wrote:
> blackaddertoo wrote:
> 
> >hi again

thankyou for the help.

yes i'm trying to change the discs and rebuild calipers.

i must admit i have not seen a screw, does this just hold the disc 
onto the hub? and is it at the front or back?

i spotted last night that there are access holes for a socket for 
the calipers, (although drive shaft is a bit in the way for one of 
them. have got one two move with my extending socket set.

i'll take a look later as i would like to do this without touching 
the hub nut (270!!!!)

i thought the set up might be like the front ie remove hub to change 
the discs.

thanx again for any help

a bit frustrating as i have never driven her (after about 6 months!)

regards

Steve

> > Hi All
> >
> > my rebuild of vin 1621 is going ok (but slow) but i've come to 
the
> > rear brakes.
> >
> > Does anyone know if it is ok to put into gear (manual) to stop 
rear
> > wheel and hub nut turning.
> 
> STOP! You don't need to remove the hub to take the disc off (I 
assume 
> that's what you're doing). Just undo that piddly screw with an 
impact 
> driver and tap it off.
> 
> >
> >
> > Also are there any tips on removing the rear calipers. 
> 
> 16mm spanner, ring end and a hammer to get it started, than a 16mm 
> socket on a 3/8 extension, there is a n access hole in from the 
other 
> side on the top one.
> 
> Martin





DOC UK Website: www.deloreans.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine **

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/doc-uk/
   
• To unsubscribe from this group, send an email to:
  doc-uk-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.