Chris - you're a star! I'll give you first refusal on the first batch :-) Chris Parnham wrote: > Martin, > > The external diameter is 65mm > The top length is 190 mm > The bottom length is 117 mm > > That should give the proper angle. > > They should be welded on (tacked) so that the old inner pipe is just level > with the bottom bit.(117mm). > > Hope that's clear enough! The things I do for you boys, laying on my back > under my cold car port, with my glasses on, torch in hand etc. etc. > > Arkwright! > > -----Original Message----- > From: Martin Gutkowski [mailto:webmaster@xxxx] > Sent: 13 March 2002 09:43 > To: doc-uk@xxxxxxxxxxxxxxx > Subject: [doc] Flared tailpipes > > Hiya > > Can someone tell me the outside diameter of the '83 flated exhaust tips > please? I know a tubesmith quite well and would like them to make up > some to fit the DeLorean - I dislike my "pea-shooters". > > Is the cut on the flaring 45 degrees? > > Cheers > > Matin > > DOC UK Website: www.delorean.co.uk > Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxx > ** Unless otherwise stated, all messages posted to the group are assumed > public and may be printed in the club magazine ** > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > > DOC UK Website: www.delorean.co.uk > Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxx > ** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine ** > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/