Hi Matt and everyone else, Thank you all for the advice offered. You guys are great! ;) Your advice is the best and this is the way I will go. I just spoke with someone who knows how to seal engine parts and they suggested using an anaerobic gasket maker. I just bought it online and will use that to reseal my transmission. Thank you again for your help. The transmission is removed from the car as is the engine. I have just separated the transmission from the engine to inspect the clutch and to fix any leaks that I might have. I will have no problem with separating the transmission casing as it's just a few bolts now that the transmission is sitting on the floor. I will be getting ready to put everything back onto the new stainless frame and so this is the time take care of that. The leak is not catastrophic but the lower lip of the tranny is covered with oil. I might get a drop or two of oil on the garage floor after I park the car. Yet, cars are very closely inspected here and you will not pass inspection if they find any leaks. Even if the oil is not dripping off of the engine, just a 'wet' transmission as in my case is enough to fail the inspection. Last time I went to get the car inspected they found the leak but it was so small that the transmission was just dirty (greasy residue) and they let me pass. They said that I will have to fix it next year if it gets any worst. Then it got cold and it got a lot worst and so I have to fix it. Besides, I don't like any leaks myself. Those greasy spots on the parking lots mostly come from the A/C water washing off any reside from under the car. The parking lots here do not really have those spots. David, Stephen - an answer to your question is that I'm 100% sure it's coming from between the two halves. I've seen it when the leak was just forming and it started about half way between the drive axles and the front cover. The axles have a leak as well and I will need to fix both of those problems. Thank you!! Greetings from Poland! Tom Niemczewski Vin 6149 plus 2418, 3633, 5030, 16473, 17086 Google earth: 52°25'17.66"N, 21° 1'58.40"E -------------------------------------------------- From: "Matthew" <drivestainless@xxxxxxxxx> Sent: Sunday, January 08, 2012 6:56 PM To: <dmcnews@xxxxxxxxxxxxxxx> Subject: [DML] Re: Manual transmission oil leak > Tom, > > I find it amazing cars in Poland are under such strict regulation with > regard to leaks, considering that almost every car has a "moist" seal here > or there. One look at a public parking lot would surely seem to suggest > so, anyway. > > If the leak is coming from between the halves, the only advised sealer is > Permatex Anaerobic gasket. Silicone will not work, nor hylomar. > > http://www.permatex.com/products/Automotive/automotive_gasketing/anaerobic_gasket_makers/Permatex_Anaerobic_Gasket_Maker_b.htm > > You will see that it says explicitly for use with aluminum transaxle > casings. > > It is a LOT of work to do this. If the leak isn't bad, I would be tempted > to put it off until it is, and simply top off your gear oil with every oil > change. I've done re-sealed the transmission 4 different times, and have > used it with and without the Permatex Surface Activator, which is a spray > that you can apply first to speed up the cure rate in cold weather. > > Matt > #1604 > > > > > --- In dmcnews@xxxxxxxxxxxxxxx, "Tom Niemczewski" <dmctom@...> wrote: >> >> Hello group, >> >> I need some advice... My manual transmission has a leak and I need to fix >> it. With the leak my car will not pass the annual inspection. >> The leak is coming from the bottom where the two halves meet. There is no >> gasket there and it leaks along the entire length from the front cover >> all the way back to the bellhousing. >> >> Are there any tricks? Is there a common method used to tackle this issue? >> I appreciate any ideas you might have. >> >> >> Greetings from Poland! >> Tom Niemczewski >> Vin 6149 plus 2418, 3633, 5030, 16473, 17086 >> Google earth: 52°25'17.66"N, 21° 1'58.40"E >> >> [Non-text portions of this message have been removed] >> > > > > > ------------------------------------ > > To address comments privately to the moderating team, please address: > moderators@xxxxxxxxxxx > > For more info on the list, tech articles, cars for sale see > www.dmcnews.com > > To search the archives or view files, log in at > http://groups.yahoo.com/group/dmcnewsYahoo! Groups Links > > > > ------------------------------------ To address comments privately to the moderating team, please address: moderators@xxxxxxxxxxx For more info on the list, tech articles, cars for sale see www.dmcnews.com To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnewsYahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/dmcnews/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/dmcnews/join (Yahoo! ID required) <*> To change settings via email: dmcnews-digest@xxxxxxxxxxxxxxx dmcnews-fullfeatured@xxxxxxxxxxxxxxx <*> To unsubscribe from this group, send an email to: dmcnews-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/