This post will cover a varitey of little things so please bear with me: 1. As I stated before, I bought my car with one half of the ignition key broken off in the switch. I use the half-key to start the car. I hate this. -IS- it possible for a locksmith to dig that piece out of there? I don't want to replace the switch and have a 2 key system or rekey the whole dang car because of a 1/2 inch long piece of potmetal. 2. Mike Cohee and I worked on my fuel system yesterday. Lesson learned: Don't, just don't try to install plug wires on the distributor cap by slightly lifting the air/fuel mixture unit. I've been driving around with 2 wires disconnected. Only by completely removing mine was I able to properly route and attach everything. Also, I swapped my injectors for his old, but serviceble ones. I think I have about as much power as I should. They probably clogged because I waited too long to replace the filter. Finally. I need to buy that dang WOT microswitch. No good deed goes unpunished though. I snapped a banjo bolt off and Mike cannabalized one from his engine so I could get home. Thanks Mike. 3. Today, I shone a light under the driver's seat. Lo and behold, what do I find? The plastic dust cap for the speedometer angle drive. It's in perfect condition. The square hole hasn't been rounded out. My lower cable was rusted solid and wouldn't spin so I have to replace that. How does the angle drive come out so I can check and lube it? I don't know if it's ruined too or what. I want to order all my parts at once. Thanks, Rich #5335