Refer to Service Bulletins ST-05-2/82. I know your car Serial Number is out of range for this but it is a good discussion and has a detail diagram that may allow you to determine the source of your problem. If you study the diagram you will see that after you remove the relay you can check to see if 1) the ignition switch is supplying power at the start position 2) If there is sufficient power being supplied to the relay to activate the solenoid (power to terminal 30/51) 3) If the neutral safety switch/ground for the relay is present. Also, you can, if you feel qualified, jumper the solenoid (30/51 to 87) to see if it will activate the starter. Harold McElraft - 3354 --- In dmcnews@xxxxxxxxxxxxxxx, "Paul Salsbury" <paul.salsbury@xxxx> wrote: > Help I have a starting issue again.... > > Please help going nowhere fast. > > Paul > #6463 > > > [Non-text portions of this message have been removed]