Re: New master clutch problem
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: New master clutch problem



I think this is a worthwhile mod too. My only improvement would be to
go UP with it. I like to bleed with pressure and your way could trap
an air bubble at the point where you bend the "U" in the pipe to point
it downward. By going up any air would naturally move upward and out.
A bleeder screw could be modified so you wouldn't have to change the
slave cylinder or maybe just a short piece of hose with the correct ends.
David Teitelbaum
vin 10757


--- In dmcnews@xxxxxxxxxxxxxxx, "Toby Peterson" <tobyp@xxxx> wrote:
> Bill and List - I have always been unhappy with the way the DeLorean 
> clutch slave cylinder bleeding is accomplished - The fluid falls onto 
> the seam between the engine block and the transmission housing that 
> creates the possibility of getting fluid onto the clutch itself. 
> Also, as mentioned in some of these posts, the procedure is a pain, to 
> say the least. I modified Winged1 to incorporate a gravity-style 







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated