Hello Aaron, Go to the photo section, I've added more pics and instructions on how to remove the dash. On a difficulty level between 1 and 5. (5 being the hardest) This would be a 2. Remember there are no mods what so ever. If you need further instruction send me an email. I purchased my LED's from http://www.myroadster.net/led.asp they have the best prices. I bought a total of 16 Hyper-Bright Bulbs for the dash. 6 Red Warning Lights - Hyper-brite Red - #194HR 5 Dash Illumination - Hyper-brite Red - #194HR 1 Amber Fuel Light - Hyper-Brite Amber - #194HA 3 Green Turn/Low Beam - Hyper-Brite White - #194HW 1 Blue High Beam - Hyper-Brite White - #194HW Note: the battery light will not work with the LED installed. Until the Load Equalizer arrives and I can get it to work I might not install it. So if you order yor light just forget that one for now, then you only need 15 total. Also, you don't need to use red for your illumination, white works just as well. Blue would probably work too. But sorry haven't tested blue. Those bulbs also can be used for your door lights. You would need 4 Hyper-bright Amber and 2 Hyper-brite Reds. The benefit, you can leave your doors open without worrying about killing the battery right away. One time I left my door ajar and the lights were on all night. The next afternoon (about 20 hours later) the car started no problem. The LED dome Light arrived today, pretty cool. The LED's are pretty tiny but put out almost as much light as the stock ones. They are more of a darker white than the stock yellow illumination. I ordered one to try it out for the interior. Now I will order the rest of them. Dome Light interior Front- 44mm Long White Dome Light interior Shelf- 44mm Long White Trunk Light- 44mm Long White Engine Light- 44mm Long White (should be 37mm but 44mm will fit) License Plate Lights- 37mm Long White (2 required) http://www.lightingresearch.com/leds/led_dome_lights.htm Hope this helps, Mike Vin #1113 (the almost all LED DeLorean) [Non-text portions of this message have been removed]