I'm not a guy who likes to use a hammer to fix things but after the advice on the list I tried it. One of my cooling fans wasn't running so I jacked up the "D" and slid under it to take a look. I unplugged the fan motor wires and connected them to a 12 volt power supply. Then I tapped the back of the motor housing ever so gently. The fan turned a couple of degrees. I thought it was mearly from the vibration of the tapping but each time I tapped it turned more and more until it ran by itself! Now it seems to work properly when reconected. I'm not sure how long this "fix" will work but I can't seem to figure out how to remove the motor without taking the entire front of the car off. Any ideas and comment would be appreciated. Dave 6530 [Non-text portions of this message have been removed]