Re: toll booth window solenoids
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: toll booth window solenoids



--- In dmcnews@xxxxxxxxxxxxxxx, "David Teitelbaum <jtrealty@xxxx>"
<jtrealty@xxxx> wrote:
> It is not too technically difficult to replace the window
regulators.
> When you buy them from one of the "D" venders they can walk you
> through the procedure. One thing to be careful about, the inside of
> the door has many SHARP edges of stainless steel. The best thing you
> can do is to put duct tape over all the sharp edges before you begin
> after removing the panels. (You did buy all that duct tape that the
> government told you to didn't you?) Well now you have a good use
for it!
> David Teitelbaum
> vin 10757

Everyone should definitely heed David's "duct tape" advice. My
left-side window went off it's track and jammed in the down postion,
plus the door handle rods inside the door needed adjusting, so I had
my arm down through those cut-out holes. After I was done I went
inside the house to wash up and saw blood all over my arm and several
cuts. Funny thing is, I never felt a thing while working on the car.
Sure stung like heck afterwards though.

Richard
vin#5853






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated