Re: [DML] question on pulling an engine, HELP!
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] question on pulling an engine, HELP!



Todd - I had a similar occurrence while changing my clutch ... only I 
was dropping the tranny out the bottom. There are two bolts that 
attach a cover plate to the tranny housing, but the cover plate is aft 
of the flywheel, so the tranny comes away from the engine until the 
cover plate bottoms out on the flywheel. The cover plate is on the 
driver's side, and the bolts are very difficult to get to. One of 
them can't be seen. I hope that helps.

Toby peterson VIN 2248
Winged1 


> Sent: Monday, September 09, 2002 6:02 PM

> in here. can anyone help? the engine is loose it's
> about an inch or less away from the trans at this
> point.







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated