Question Re: Taillight Mod

["content22207" <brobertson@xxxx>]

Am considering following modification this winter:

On rear boards:
Burn positions 2 and 4 as taillights
Burn positions 2 3 and 4 as brake lights
I'd leave boards intact w/ OE single filament sockets -- insert mod
before card edge connectors. Positions 2 and 4 would be switched with
a relay triggered by 3 itself.

My question: would constant burn on 2 and 4 generate too much heat for
the bezels? That may be reason for extra large 3 (and a noticeably
smaller bulb).

Bill Robertson
#5939