RE: [DML] Memphis AC problem
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DML] Memphis AC problem



Id be VERY CAREFUL with this. Drill in the wrong place, and you could drill though your heater core or AC evaporator.

Have you tried a shop vac on the end of the drain hose?


> -----Original Message-----
> From: Delorean17@xxxx [mailto:Delorean17@xxxx]
> Sent: Wednesday, June 19, 2002 8:04 PM
> To: dmcnews@xxxxxxxxxxxxxxx
> Subject: [DML] Memphis AC problem
<SNIP>
> Everything was fine until my AC drain line got plugged 
> up(again). When 
> I came home I removed both seats and carpet sections before 
> it started to get 
> musty in there. I can unclog the drain with compressed 
> air but then it 
> clogs back up within and hour. I talked to Don Steger in 
> Memphis and he said 
> that it can be fixed without removing the entire box. He 
> said to buy a 2 
> inch hole cutter and cut out a hole in the bottom of the evap 
> box so you can 
> reach in and remove all of the junk. I think I might do this 
> tomorrow but 
> before I start I need to know where I should drill this 2" 
> hole... I don't 
> want to cut anything inside the box. Has anyone on the list 
> performed this 
> operation? Any info would be greatly appreciated.
<SNIP>





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated