Do you mean the upper seat belt mount? If this is the case and that part is loose- then you can't take the seat belt fastener bolt out. The bolt screws into the cylindrical fastener. This fastener (sorta like a huge rivnut) goes through the body to underneath the vent just to the rear of the door. Mine was spinning in place, and i fixed it (rather unelegantly) by drilling a hole through the spinning piece and the body and putting in a pin. If the piece you're referring to is the SPACER between the seat belt bolt and the body, simply tightening the bolt should be fine. The plastic piece on the upper seat belt mount just pops off... If you're talking about soemthing totally different, then nevermind... Jim 1537 On Fri, 15 Mar 2002 08:16:38 EST Soma576@xxxx writes: > hey everyone, me again! > > today i noticed a rattle in my car, so i got out to investigate. ?i > believe > the round disc that goes behind the seat belt mount on the passenger > rear > wall is the culprit. ?it is quite loose and it spins around and has > a lot of > play in it. ?the driver's side is much tighter. ?anyone know how to > fix this? > ? > > one problem might be that i have replaced my rear headliner but was > unable to > get the passenger side ceiling screw through the headliner once i > had it > installed. ?i should have drilled it out first. ?too late! ?as a > result the > black part of the wall on the side isn't mounted to the roof, so > it's a > little loose. ?this might have something to do with it? > > thanks! > Andy