Re: [DML] update on speedo noise
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] update on speedo noise



Another Question...
if you turn the LF wheel by hand while it's on jacks can you normally hear
clicks and action from inside angle drive at the start of the motion? Or
should I be working this problem until the AD is completely silent?

----- Original Message -----
From: "K Creason" <dmc4687@xxxx>
To: <dmcnews@xxxxxxxxxxxxxxx>
Sent: Sunday, October 07, 2001 1:46 PM
Subject: Re: [DML] update on speedo noise
> I can't remove my dustcap. It was kind of like glued around the cap, but
> I've broken that loose but it still won't pop out. Is it suppossed to be
> that tight?
>
> Also, I bought a quart of gear oil (85w/140) and a needle for my grease
gun.
> Which is better for the angle drive, heavy gear oil (is that heavy
enough?)
> or regular grease injected via needle & gun?
>
> ----- Original Message -----
> From: "K Creason" <dmc4687@xxxx>
> Sent: Saturday, October 06, 2001 8:25 AM
> > I've been trying to narrow down the source of my speedo noise. To recap,
> the
> > speedo works great, is accurate, but it there is a clicking noise, at
> least
> > up to 45mph. At a slight roll it's a very loud clack, but is only every
> few
> > seconds. At 40mph is isn't always noticeable, and there is just a slight
> > shiver to needle.

>






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated