Right rear body panel removal
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Right rear body panel removal



Group,

I am in the process of removing my right rear body panel and have run up
against a challenge. 

In the manual, Section P:02:03, it gives the procedures for quarter panel
removal. Steps 1 and 2 are no problem, but where are the "two screws from
each side, securing the rear facia reinforcement brackets to rear body
pontoons"? These are described in step 3.

Are these the stainless steel bolts on each side just in front of the outer
edges of the facia, but under the channel for the louvers? Removing them
does not allow me to "ease back end of rear facia and remove four screws
securing edge of fender to pontoon bracket" per step 4. I can get to the
upper one, but not the lower ones. Removing the bolt on the right (which has
a wire attached) does allow the panel to come loose from the bracket.

Can someone help me identify these screws so I can continue??

Steve
#3542







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated