I am getting a small dent removed from the door of my D, on July 9th. The owner of a large Body shop here, formerly did body work on DeLoreans as part of the original QAC facility and is familiar with this work.........however they will use a relatively new technique on this one.....they have a machine that has several "fingers" on it that are epoxied to the metal and will PULL the metal out versus pushing it from the backside. When the job is done the contact points are heated and the expoxy lets loose and it is ready for texturing...... This is a quite small dent, ( 1/8 inch deep and tapering out a few inches) but noticeable, and I have been putting off having it done for a couple years, although it is fully covered by insurance. One question he asked, was whether I knew HOW that side door body molding is fastened. Is it cemented to the stainless, as we both suspect or are there bolts or fasteners of some sort. How is it removed and can it be recemented back on? He would like to take it off to facilitate this dent removal and it has a VERY slight bend in it too, which would come out when it is put back on. Can someone comment on taking this Vinyl body molding off and putting it back on? Adhesive? Thanks. Murray Fisher Vin: 05962 Lic: DMC-XII Washington State [Non-text portions of this message have been removed]